Configured, but errors when printing

[david raeman <ralusp@xxxxxxxxxx>]

I'm using apsfilter 7.2.2, ghostscript afpl 7.04, hpijs 1.0.3,
samba 2.2.3a, and lprng 3.8.9.

I'm attemping to print to a HP OfficeJet 710 through Samba (the printer
is conntected to a winxp box and is shared).  After setting the appropriate
settings in apsfilter (ijs 1.0, samba settings, etc), I attempt to print
a test page from apsfilter and get these errors:

  unable to set key=OutputFile, value=/tmp/apsfilter28699/test_page.aps
  unable to set key=Quality, value=0
  [a couple dozen more of these, with different key and value settings]

followed by this being written to my screen infinitely:

  unable to write to output, fd=0, count=1000: Bad file descriptor

If I attempt to save settings and use lpr, the job queues and then I can
see the same errors occuring in the status line of `lpq`.

The printcap entry that it creates is:

  oj710|ijs/DESKJET_610;r=300x300;q=low;c=gray;p=letter;m=auto:\
      :lp=/dev/null:\
      :if=/etc/apsfilter/basedir/bin/apsfilter:\
      :sd=/var/spool/lpd/oj710:\
      :lf=/var/spool/lpd/oj710/log:\
      :af=/var/spool/lpd/oj710/acct:\
      :mx#0:\
      :sh:


All of the above software was compiled from source using gcc 2.95.3
and glibc 2.2.5 on a linux 2.4 box.  If anybody could offer any
suggestions, I'd GREATLY appreciate it.  =)

Thanks!






-- 
... david raeman ; ralusp@ralusp.net ; http://www.ralusp.net
\ the surest way to corrupt a youth is to instruct him to hold in higher
/ esteem those who think alike than those who think differently  -nietzsche